After familiar with the components of Sonic Mini 8K S, we are now ready to set up your Phrozen Sonic Mini 8K S 3D printer and start a enjoyable 3D printing journey.
Step 1: Begin by loosening the screws beside the resin vat and then take it out.
Step 2: Next, peel off the protective film on the LCD before you start printing with the Sonic Mini 8K S.
Step 3: Plug the power cable in to the port on the back of the Sonic Mini 8K S.
Step 4: Turn on the switch. It may take a few seconds for the touch panel to light up. Once you hear a beep sound, that means the device is ready for use.
Now we can proceed with performing an LCD Test on your Sonic Mini 8K S.
1 comment
sovann
I have trouble printing because when I print the bottom thickness is thick. Can you help me with this solution, what settings to choose, do not let it matter. Thank you
———
Phrozen Technology replied:
Hello Sovann, Thank you for commenting.
You will have to print the testing models such as XPFinder to determine the optimal resin setting for your setup. If you are using a Phrozen branded resin, we’ve provided resin profiles for our customers to use as a starting point when they are dial in the resin, which you can find on this page: https://phrozen3d.com/pages/resin-profile
And here’s an article on how to dial in the resin by reading results from the XPFinder, which you might want to take a look: https://helpcenter.phrozen3d.com/hc/en-us/articles/6324821843993-How-to-Dial-in-Resin-for-Optimal-Results
Hope this helps.
Best, Phrozen Team
>
I have trouble printing because when I print the bottom thickness is thick. Can you help me with this solution, what settings to choose, do not let it matter. Thank you
———
Phrozen Technology replied:
Hello Sovann, Thank you for commenting.
You will have to print the testing models such as XPFinder to determine the optimal resin setting for your setup. If you are using a Phrozen branded resin, we’ve provided resin profiles for our customers to use as a starting point when they are dial in the resin, which you can find on this page: https://phrozen3d.com/pages/resin-profile
And here’s an article on how to dial in the resin by reading results from the XPFinder, which you might want to take a look: https://helpcenter.phrozen3d.com/hc/en-us/articles/6324821843993-How-to-Dial-in-Resin-for-Optimal-Results
Hope this helps.
Best, Phrozen Team
>