Advice and answers from our team

This article includes:

  • How to connect your LCD 3D printer to Phrozen OS Interface?
  • How to upload new files to Phrozen OS Interface?
  • How to add new resins on Phrozen OS Interface
  • What can you change from the touch panel on your printer?

 

How to connect your printer to Phrozen OS Interface?

  1. Select WIFI on the touch panel. 

 

2. Choose the WiFi you would like to connect. Please make sure your computer is connected to the same WiFi as your printer.  

 

3. Once the printer has successfully connected to WiFi, you will see the IP address on the top of the touch panel.

 

4. Open Google Chrome and type in the IP address as shown on the resin 3D printer  

  

5. Voila! You have successfully entered Phrozen OS Interface!

 

How to upload new files to Phrozen OS Interface?

Once you have entered Phrozen OS Interface, click “PLATE” on the top right corner of the page, then select the file from your computer and upload it to the printer.

In addition to uploading files on Phrozen OS Interface, we also recommend you to upload new files via USB to your printer.

 

On the same page, you will see the files that you have previously uploaded. You may print it again, modify the resin profile, or delete the files.  

 

How to add new resins on Phrozen OS Interface

After setting supports and slicing the print in the slicing software (see link), you may wish to modify a few settings on Phrozen OS Interface before you start printing. Please click on “PROFILE” on the top right corner of the page.

If you need to modify or add new resins to the resin profile, you need to change the settings on Phrozen OS Interface as the printer will not read the settings on the slicers, except for the layer height. 

Please see the steps below for how to add new resins to the profile:

Step 1: Type in the resin name.

Step 2: Set the thickness (layer height). Make sure the layer height is the same as it is in the slicing software.

Step 3: Set the down speed.

Step 4: Set the light-off delay time according to this calculator.

Step 5: Set the burn layers count at 6~10

Step 6: Set the burn layer exposure time

Step 7: Set the burn layer lifting height

Step 8: Set the burn layer up speed

Step 9: Set the normal layer exposure time

Step 10: Set the normal layer lifting height

Step 11: Set the normal layer up speed

Step 12: Click “ADD” then your printer will now remember this resin profile!

*Please see the official Phrozen Resin Profile here*

 

What settings can you modify from the touch panel?

  1. Burn layer exposure time (ms)
  2. Burn layer count
  3. Normal layer exposure time (ms) 

 

Tips:

  1. Official Phrozen Resin Profile 
  2. How do I adjust the Profile Settings for My LCD 3D Printer and Resin? 

Did this answer your question?